CMP 25568-301-000 Rope Eye Male Gray, Vinyl Liner, W/Male Screw, Washers,Gaskets, Nut

Overview

This replacement rope eye kit restores a watertight external rope anchor for vinyl liner pools. Molded from UV stabilized resin and supplied with a rubber sealing gasket plus corrosion resistant hardware this kit provides a durable replacement for damaged or worn rope anchors. Read the compatibility and installation guidance to confirm fit and ensure a leak free repair.

What is included

• Molded rope eye made from UV stabilized resin for UV and chemical resistance
• Male screw with corrosion resistant finish
• Nut and two matching washers for even compression and a secure seal
• Rubber sealing gasket to form a watertight seal against the liner

Key benefits

• Durable UV stabilized resin reduces cracking and discoloration from sun and pool chemicals
• Corrosion resistant hardware minimizes rust and staining on liner and coping
• Neutral gray color blends with common liner anchor plates for a clean appearance
• Compact single anchor kit allows spot repairs without removing or replacing the liner
• Compatible with many external anchor configurations made by common manufacturers for easy replacement

Technical specifications

Compatibility and fit guidance

This kit is designed for vinyl liner pools that use an external rope anchor with a male screw style fastener. Many pool liners and anchor backing plates use similar thread configurations but sizes vary. Confirm fit by taking three measurements from your existing anchor and comparing them to the measurements below.

Required measurements to confirm fit

• Anchor hole diameter across the liner measured edge to edge using calipers or a precise ruler
• Threaded screw diameter across the threads measured with calipers to determine thread size
• Screw length measured from beneath the screw head to the end of the threads to ensure proper engagement into the backing plate

How to confirm fit

• Compare your measurements to the dimensions of the existing anchor before ordering
• If unsure provide a clear photo of the existing anchor the part number and the three measurements to customer support for verification

Step by step installation

• Turn off the pool pump and remove rope and floats from the work area
• Drain to a level that provides access to the anchor or work from inside the pool if possible
• Remove old hardware and clean the liner seating area of old gasket material so the new gasket sits flat against the liner
• Place the rubber sealing gasket between the liner and the molded rope eye and align the hardware through the anchor hole
• Install screw nut and washers for even compression and tighten until the gasket seals the liner while avoiding over tightening that can damage the liner
• Refill the pool if you drained and inspect the repair area for leaks and correct float line alignment

Tools and time

• Common tools include a screwdriver or nut driver a torque limiting hand tool a clean rag and a utility tool to remove old gasket material
• Typical install time for one anchor is 10 to 30 minutes depending on access and condition of existing hardware

Maintenance and care

• Inspect rope eyes periodically for cracking gasket compression and hardware corrosion
• Replace gaskets washers or hardware at the first sign of wear to maintain a watertight repair
• Rinse exposed hardware with fresh water after heavy chemical treatment to extend part life

Technical notes and best practices

• Use the included sealing gasket and ensure even washer compression to help prevent leaks and liner damage
• When replacing multiple rope anchors inspect all rope eyes and replace any that show deformation cracking or uneven seating to maintain consistent float line alignment
• Avoid overtightening hardware to prevent compressing or damaging the liner material
• If uncertain about fit or installation provide the part number and a clear photo to a qualified pool technician or customer support for verification

Compatibility checklist for faster verification

• Measure anchor hole diameter thread diameter and screw length before ordering
• Compare measurements to the existing anchor or backing plate thread engagement depth
• If you supply a clear photo with measurements customer support can usually confirm fit quickly

Frequently asked questions

• Will this kit work with my liner anchor plate Most installations that use a male screw style external anchor are compatible but always confirm measurements
• Is the gasket reusable Replace the gasket if it shows signs of compression cracking or permanent deformation to maintain a watertight seal
• Can I overtighten Yes avoid over tightening as that can damage the liner or cause uneven seating