Arctic Custom Series Topside Controls
Arctic Custom Series Topside Controls
Your spa control has been specifically designed so that by simply connecting the spa to a properly grounded source, and following the start-up procedures in this manual, the spa will automatically heat to the set temperature. Many other functions, such as filtration, safety checks and maintenance reminders have been automated so that your spa experience will be as carefree as possible.
But you’re in charge! The topside control (TSC) panel allows you to set the temperature, initiate the filtration cycle, control the lights, and activate or deactivate the pump(s). The TSC display responds to let you know you have pressed a button, and that the selected function has been performed. 
Starting Pump 1:
Press Pump 1 button to turn on at low speed. Press a second time to turn Pump 1 to high speed. A third time turns the Pump 1 off. A built in timer automatically turns Pump 1 off after 20 minutes, unless it has been manually deactivated.
Starting Pump 2:
Press Pump 2 button to turn on Pump 2. Press a second time turns Pump 2 off. A built in timer automatically turns Pump 2 off after 20 minutes, unless it has been manually deactivated.
Starting Pump 3:
Press Pump 3 button to turn on Pump 3. Press a second time turns Pump 3 off. A built in timer automatically turns Pump 3 off after 20 minutes, unless it has been manually deactivated.
Starting SDS:
If available, press SDS button to turn on SDS. Press a second time turns SDS off. A built in timer automatically turns SDS off after 20 minutes, unless it has been manually deactivated SDS.
Setting Water Temperature:
Use the Up or Down Arrow button to regulate water temperature. The temperature setting will be displayed for 5 seconds to confirm your new selection.
Programming the Filter Settings:
During a filter cycle - Pump 2, Pump 3 and the blower run for 20 seconds. then Pump 1 runs at low speed for the programmed number of hours (see below), and the ozonator is turned on.
Press your Filter button again. Your display will now show the settings for your Filter Duration.
Use your arrow keys to select your Filter Duration in hours. You can select from 0 to 6 hours.
Press your Filter button again. Your display will now show the settings for your Filter Cycle Frequency.
Use your arrow keys to select your Filter Cycle Frequency from 1 to 4 times per day.
Note: You will see the options that are applicable to your spa. If you have neither ozone nor onzen, you will proceed directly into setting your Filter Duration. Also, though an Epic topside is of a different design, the steps are as shown. You can move backwards through the settings by pressing the Pump 3 button (Pump 4 on Epic series spas). The Pump 1 button will allow you to exit without saving any changes. When you get to the end of the options, press the filter key one last time to save changes and begin a filter cycle immediately. If you do not press the filter key again your changes will be saved and the filter cycle will begin when you have programmed it to do so.
