Arctic Core Series Topside Controls

Pump 1: 

Press Pump 1 key to turn Pump 1 on at low speed. Press second time to turn pump to high speed. A third time turns pump off. A built-in timer automatically turns pump off after 20 minutes unless pump has been manually deactivated first. The “Pump 1” indicator lights up when Pump 1 in on. The indicator will flash when pump 1 is on at low speed.  

Pump 2:

Press Pump 2 key to turn Pump 2 on at high speed. Press a second time turns pump off. A built-in timer automatically turns pump off after 20 minutes unless pump has been manually deactivated first. The “Pump 2” indicator lights up when Pump 2 in on. 

Light Key:

Press Light Key to turn lights on. A second press turns lights off. A built-in timer automatically turns light off after 2 hours unless it has been manually deactivated first. The “Light” indicator lights up when light is on. 

Up / Down Keys:

Use Up or Down key to set desired water temperature. The temperature setting will be displayed for 2 seconds to confirm your new selection. 2 pump spas have a combined Up/Down Key. Hold the button to increase the parameter and release the button to stop. Hold the button again to decrease the range.  

Program Menu:

The program menu is accessible by holding down the Light key for 5 seconds. In the program menu the following parameters can be set: clock, filter or purge cycles, economy mode and temperature units. While in the program menu, use the Up or Down key to adjust the parameters and use the Light key to jump to the next parameter. The changes will be saved after the confirmation of the last parameter only. If there is no action taken for 10 seconds, the system will exit the program menu without saving any changes. 

Setting Filter Cycle Start Time:

The display will show FSxx, “xx” representing the starting hour of the cycle. Use the arrow keys to adjust the hours. Use the Light key to jump to the next parameter, filter duration (Fd). 

Setting Filter Cycle Duration:

The display will show Fdxx, “xx” representing the duration in hours of the filter cycle. Use the arrow keys to adjust the duration. Use the Light key to jump to the next parameter, filter, or purge frequency (FF).  

• 0 = no filtration (It is not recommended to set this to “0”)
• 24 = continuous filtration 

Setting Filter Cycle Frequency:

The display will show FFxx, “xx” representing the number of cycles per day. Use the arrow keys to adjust the frequency. Use the Light key to jump to the next parameter, Onzen Cycles (OC).  

• The “Filter” indicator lights up when filter is on and flashes when suspended. 

Setting Economy Mode:

This mode allows you to lower the temperature set point of the spa by 20 °F (11 °C) during a certain period of the day. The display will show EPx, “x” representing the state of the programmed economy (0 = disabled, 1 = enabled). Use the arrow keys to enable or disable economy mode. Use the Light key to jump to the next parameter, economy start time (ES). When the Economy mode is ON, the display will toggle between the “Eco” message, the time, and the water temperature. 

Setting Economy Start Time:

The display will show ESxx, “xx” representing the hour at which the economy mode will become active. Use the arrow keys to adjust the hour. Use the Light key to jump to the next parameter, economy duration (Ed). * Note that the parameters for the economy mode settings are associated to specific low level configuration of the system that are not present in all software revisions. 

Setting Economy Duration: 

The display will show Edxx, “xx” representing the duration in hours of the economy mode. Use the arrow keys to adjust the hour. Use the Light key to jump to the next parameter, temperature unit.  

• 24 = continuous economy