What Is Arctic Spas Total Access™? The Hot Tub You Can Service From Every Side

A hot tub is a machine that lives outdoors. Behind the cabinet are pumps, a heater, valves, and hundreds of plumbing connections, and a good spa is meant to last 10 to 20 years or more. Somewhere during that time, something will need attention: a pump seal, a jet fitting, a valve. When that day comes, the question is simple. Can a technician get to it? Arctic Spas® builds every spa so the answer is yes, from any side. It's called Total Access™.

Arctic Spas hot tub with a Total Access cabinet

Quick Answer: What Is Total Access™?

Total Access™ is the way Arctic builds its cabinet. Removable, insulated doors on all four sides open onto pumps, plumbing, and jet fittings that are left in the open instead of buried in spray foam. A technician takes off the door closest to the problem, sees it, and fixes it, without cutting out insulation or taking the cabinet apart.

The same open cabinet keeps equipment heat inside the spa as part of the FreeHeat™ insulation system, and it lets you add features years later, such as jets, lighting, or audio. It's standard on every Arctic spa: Custom, Classic, and Core Series.

Watch: Total Access™ Up Close

Arctic Spas shows Total Access in this short video. The full breakdown follows below.

Video courtesy of Arctic Spas®.

How You Get Inside Most Hot Tubs

Most of a hot tub's plumbing isn't in the equipment bay. It runs along the side of the spa shell in order to reach each jet. How much of it a technician can reach depends on how the cabinet was built.

Common Ways Hot Tubs Are Built

  • Full foam. Spray foam fills the cabinet and surrounds the pipes and fittings. It insulates, but a leak has to be found by cutting or digging the foam away, and the foam has to be replaced afterward. Even brands that build full-foam spas note that repairs take more labor.
  • One equipment door. Many spas have a single service door in front of the pumps and controls. That works for the equipment itself, but a jet or fitting on the far side sits behind cabinet panels and, usually, foam.
  • One-piece molded cabinets. On rotomolded plug-and-play spas, the shell and cabinet are a single piece of molded plastic, often filled with foam. There are typically no side panels to take off, so access stops at the equipment door.

None of that shows in the showroom. It shows up years later, when a small leak turns into hours of digging and a cabinet full of patched-in foam.

How Total Access™ Works

Arctic can leave the foam out because its composite shell holds itself up. With nothing packed around the plumbing, the cabinet can be built to open.

Doors on All Four Sides

Every side of the cabinet has removable access doors. A technician opens only the side that needs attention, and no wall of the cabinet has to be taken apart to do it.

Insulation That Stays Intact

The insulation is on the doors, the floor, and the cover, not sprayed over the plumbing. When a door comes off, its insulation comes with it. When it goes back on, the spa is insulated exactly as it was.

Everything in Plain Sight

Pumps, valves, pipes, and the backs of the jets sit in open air. A drip can be seen and traced to its source instead of hunted for.

Room to Add On Later

Because the plumbing is reachable, many features can be added after the spa is in your yard: jets, pumps, lighting, audio, or water care options.

Arctic Spas Total Access cabinet on a Core Series Grizzly
Total Access™ cabinet, Core Series Grizzly. Image courtesy of Arctic Spas®.
Arctic Spas cabinet under construction
An Arctic cabinet under construction. Image courtesy of Arctic Spas®.

Total Access™ vs. Other Hot Tub Designs

What Matters Full-Foam Acrylic Spa Rotomolded Plug-and-Play Spa Arctic Spas With Total Access™
Getting inside Usually one equipment door; the other sides are behind cabinet panels and foam One equipment door; the rest of the cabinet is typically one molded piece Removable, insulated doors on all four sides
What's around the plumbing Spray foam fills the cabinet and surrounds pipes and fittings Often foam-filled Open air; the insulation is on the doors, floor, and cover
Finding a leak Foam is cut or dug away until the wet spot is found Limited to what can be reached from the equipment area Take off the nearest door and look
Insulation after a repair Removed foam has to be patched or re-sprayed Varies by model Unchanged; the door goes back on
Adding features later Difficult once the plumbing is foamed in Usually sold as a fixed package Many features can be added, such as jets, pumps, lighting, and audio

Typical designs are based on published product information from hot tub manufacturers, checked November 2026. Construction differs by brand and model, so confirm the details for the exact spa you're considering.

Arctic Spas Custom Series diagram from the Arctic Spas brochure
Arctic Custom Series spa. Image courtesy of Arctic Spas®.

Why It Matters in Minnesota

Winter Repairs Without the Dig

Snow, ice, and subzero wind make any outdoor repair harder. Taking a door off and reaching straight to the problem is a very different job in January than cutting foam out of a cabinet in the cold.

Less Time With a Cold Spa

In a Minnesota winter, a spa that's shut down for repair is a spa that's cooling off. The faster a problem is found and fixed, the sooner the water is hot again. And because the doors come off right where the spa sits, service rarely means moving it.

Access Without Giving Up Warmth

The open cabinet isn't a trade-off against insulation. It's the same space that holds the heat from the pumps and keeps the plumbing warm, even through a power outage. Here's how FreeHeat™ works.

A Spa You Can Keep Up to Date

A hot tub you'll own for 15 or 20 years will outlast some of its own technology. With the plumbing in reach, you can add or update features over time instead of trading in the whole spa.

Leave room to take the doors off. Total Access only helps if a technician can get to the doors. Arctic's owner's manual calls for at least 24 inches of clearance on all four sides, and keeping that space open is the owner's responsibility. If you're planning to put your spa against the house, in a corner, or down into a deck, talk to us first so we can plan the access with you.

Which Arctic Spas Have Total Access™?

  • Custom Series: Included as standard.
  • Classic Series: Included as standard.
  • Core Series: Included as standard.

Arctic's All-Weather Pools (swim spas) are built with access doors on all four sides, too.

Shopping for a Spa? Ask Every Dealer These Questions

Whatever brand you're considering, these questions will tell you what a repair will look like years from now:

  1. How many sides of this spa open for service?
  2. What's around the plumbing? Open air, or spray foam?
  3. If a jet leaks on the side away from the equipment door, how do you get to it?
  4. If insulation is cut out for a repair, how is it put back?
  5. Can features be added later? Or is the spa fixed the way it was built?
  6. How much clearance does the spa need around it for service?

Frequently Asked Questions

Do the doors really come off on every side?

Yes. Arctic builds its spas with access doors on all four sides, and each door can be removed for service.

If the plumbing isn't packed in foam, won't the spa lose heat?

No. Arctic insulates the doors, the floor, and the cover instead, so the heat stays inside the cabinet with the equipment and the water. Here's how FreeHeat™ works.

Is Total Access™ the same thing as FreeHeat™?

They're two parts of one design. FreeHeat™ is how the spa is insulated: around the outside of an open cabinet. Total Access™ is how you get into that cabinet: through removable, insulated doors on every side.

Can I add jets or other features after I buy?

In many cases, yes. Because the plumbing is in the open, features like jets, pumps, lighting, audio, and water care options can often be added later. What's possible depends on the model, so ask us about the spa you own or the one you're considering.

Can I put my spa against the house or build a deck around it?

It can be done, but it takes planning. Arctic's owner's manual calls for 24 inches of clearance on all four sides so a technician can reach every door. If your plan puts a wall or deck closer than that, talk to us before delivery about ways to keep the doors reachable.

Do all Arctic Spas have Total Access™?

Yes. It's standard on Custom, Classic, and Core Series hot tubs, and Arctic's All-Weather Pools have access doors on all four sides as well.

Can I see Total Access™ in person?

Yes. We have Arctic Spas on display in our Chanhassen showroom, and we're happy to take a door off and show you what's behind it.

See Total Access™ in Person in Chanhassen

Premier Pool & Spa is the Twin Cities' Arctic Spas showroom. Come see the lineup, look inside a cabinet with the door off, and talk through which model fits your yard and your winter.

Premier Pool & Spa
2985 Water Tower Place
Chanhassen, MN 55317
Call or text: 952-368-6070

Images and video courtesy of Arctic Spas®. Total Access™, FreeHeat™, Forever Floor®, Mylovac™, and Arctic Spas® are trademarks of Blue Falls Manufacturing.